Requirements for use of canned heat sources and hose connections

The canned heat source is characterized by smokeless, odorless, non-toxic, non-volatile, and stable and stable burning time.

Before using the liquefied gas in the canned heat source, it is necessary to carefully check whether all the pipes, joints, valves, etc. connected to the liquefied gas cylinder are intact, prevent the aging of the hose, the interface from falling off, etc., and prevent the liquefied gas from leaking.

Liquefied appliances are required to be replaced once every six months by using rubber hoses. The iron pipes are replaced according to the requirements of the national administrative department, and daily safety inspections are carried out to deal with hidden dangers at any time. If the pressure reducer, seal ring, etc. are aged and corroded within the service life, they should be replaced immediately. It is strictly forbidden to use a hose connection between the cylinder and the gas appliance or the gas supply system.

Check the sealing rubber band before the pressure source of the canned heat source, with or without deformation and defect. Install the pressure reducing valve handwheel to the positive valve port and turn it counterclockwise. It is forbidden to forcibly switch the liquefied gas cylinder angle valve in any way. Liquefied gas cylinders must be inspected regularly and pressure tested. If the conditions are not met, they must be compulsory.www.wickchafingfuel.com