Things to note before operating an alcohol fireplace

1. Place the alcohol fireplace horizontally, and make sure there is no igniting material within half a meter of the furnace body and the area where the alcohol fireplace is placed must be flat without too much height difference. If there is really no better choice, it can also be installed in a place where the slope angle is less than 15°. Once this value is exceeded, the built-in anti-dumping self-locking device of the alcohol fireplace will be activated, the body will alarm and lock, making it impossible to open.

2. Connect the power supply (depending on the model, some alcohol fireplaces may be imported from abroad, in which case a conversion plug is required, generally speaking, 110V-240V sockets can be used), turn on the machine; if using indoor AC power, please confirm again and again that there is a leakage circuit breaker protection device.

3. Usually there is a plastic nozzle near the panel door of the alcohol fireplace. This is where we will add fuel in the future. The operation is very simple. Take the hose that comes with the fireplace, connect one end to the plastic nozzle, and put the other end into the alcohol fuel. Then press the filling switch to start filling the fuel. When used for the first time, if the alcohol fireplace is not filled with enough fuel within 30 minutes, the machine will alarm and self-lock. In this case, there is no need to panic, just add it normally until it is fully filled. The whole filling process is very simple. If alcohol spills, it can be used safely after wiping it.

https://www.wickchafingfuel.com/